Switch User Manual

116 IP Routing Configuration and Management
show ip dhcp-relay counters command
The show ip dhcp-relay counters command displays the current
DHCP relay counters configuration globally on the Nortel Ethernet Routing
Switch 5500 Series. This includes the number of requests and the number
of replies.
The syntax for the show ip dhcp-relay counters command is:
show ip dhcp-relay counters
The show ip dhcp-relay counters command is executed in the User
EXEC command mode.
ip dhcp-relay clear-counters
The ip dhcp-relay clear-counters command clears the counters
for an interface.
The syntax for this command is:
ip dhcp-relay clear-counters
This command is executed in the Interface Configuration command mode
while editing a VLAN only.
This command has no parameters.
show ip dhcp-relay fwd-path command
The show ip dhcp-relay fwd-path command displays the current
DHCP relay forward path configuration globally on the Nortel Ethernet
Routing Switch 5500 Series which includes the interface, the server, the
state (enabled or disabled), and the mode.
The syntax for the show ip dhcp-relay fwd-path command is:
show ip dhcp-relay fwd-path
The show ip dhcp-relay fwd-path command is executed in the User
EXEC command mode.
ip dhcp-relay fwd-path command
The ip dhcp-relay fwd-path command sets the mode for the specific
forwarding path DHCP relay settings globally on the Nortel Ethernet Routing
Switch 5500 Series.
The syntax for the ip dhcp-relay fwd-path command is:
ip dhcp-relay fwd-path <A.B.C.D> <O.P.Q.R>
The following table outlines the parameters for this command.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.