Switch User Manual

IP routing configuration using the CLI 119
The show vlan dhcp-relay command is executed in the User EXEC
command mode.
ip dhcp-relay command
The ip dhcp-relay command allows configures DHCP relay settings
on a VLAN.
The syntax for the ip dhcp-relay command is:
ip dhcp-relay [min-sec <0-65535>] [mode {bootp | dhcp |
bootp_dhcp}]
The following table outlines the parameters for this command.
ip dhcp-relay parameters
Parameter Description
min-sec <0-65535> Enter the minimum number of seconds to wait
between receiving the DHCP packet and forwarding
it to the destination device. The default is 0.
mode {bootp | dhcp |
bootp_dhcp}
Enter the type of DHCP packets this VLAN supports:
•
bootp - Supports BootP only
•
dhcp - Supports DHCP only
•
bootp_dhcp - Supports both BootP and DHCP
The ip dhcp-relay command is executed in the Interface Configuration
command mode.
no ip dhcp-relay command
The no ip dhcp-relay command disables DHCP relay on a VLAN.
The syntax for the no ip dhcp-relay command is:
no ip dhcp-relay
The no ip dhcp-relay command is executed in the Interface
Configuration command mode.
ip dhcp-relay broadcast command
The ip dhcp-relay broadcast command enables DHCP relay
broadcast on a VLAN.
The syntax for the ip dhcp-relay broadcast command is:
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.