Switch User Manual

122 IP Routing Conﬁguration and Management

Adding a static ARP entry to a brouter port

To add a static ARP entry to a brouter port, use the ip arp command. This

command has the following syntax:

ip arp ip <ip_address> mac <mac_address> port <port_number>

vid <vid_number>

The following table outlines the parameters of this command

ip arp parameters

Parameter Description

ip_address The IP address of the entry.

mac_address The MAC address of the entry.

port_number The slot/port number of the brouter port.

vid_number The VLAN ID of the entry.

The following is an example of adding a static ARP entry to a brouter port:

5530-24TFD(config)# ip arp 172.2.2.13 00:00:98:22:33:44 1/46

vid 1

Deleting a static ARP entry

To delete a static ARP entry, use the no ip arp command. This command

has the following syntax:

no ip arp ip <ip_address>

The <ip_address> parameter represents the IP address of the entry to

delete.

The following is an example of deleting a static ARP entry:

5530-24TFD(config)# no ip arp 172.2.2.13

Note: Deleting a static ARP entry is applicable to both VLANs and

brouter ports.

Routing Information Protocol (RIP) conﬁguration

This section provides examples of the common RIP conﬁguration tasks and

includes the CLI commands used to create the conﬁguration.

RIP conﬁguration tasks

RIP is conﬁgured on a VLAN or brouter port basis. This section presents the

steps in RIP conﬁguration and accompanying command syntax examples.

To conﬁgure RIP on an interface, perform the following steps:

Nortel Ethernet Routing Switch 5500 Series

Conﬁguration-IP Routing Protocols

NN47200-503 03.01 Standard

5.1 27 August 2007