Switch User Manual

128 IP Routing Configuration and Management
interface vlan 3
no ip rip listen enable
no ip rip supply enable
! *** Brouter Port *** !
interface fastEthernet ALL
brouter port 2/7 vlan 3 subnet 10.1.1.1/30
The following commands can be used to confirm the configuration of RIP
parameters:
Command
Description
show vlan
This command is used to display information about the
currently configured switch VLANs.
show vlan ip
This command is used to display IP address information
about VLANs that have been assigned addresses on the
switch.
show ip rip
This command displays information on the global switch RIP
configuration.
show ip route
This command displays the switch routing table.
show ip rip
interface
This command displays information about the RIP interfaces
present on the switch.
Configuring RIP version 2
When RIP is enabled on an interface, it operates by default in
rip1compatible send mode and rip1orRip2 receive mode. Depending on
configuration requirements, the Nortel Ethernet Routing Switch 5500 Ser ies
can be configured to operate using RIP version 1 or 2. The configuration
illustrated below demonstrates a Nortel Ethernet Routing Switch 5500
Series switch that has been configured to operate use RIP version 2 only.
Note: This example builds on the previous RIP configuration.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.