Switch User Manual

IP routing conﬁguration examples 131

Accept policy conﬁguration

Use the following steps to recreate the above conﬁguration example:

Step Action

Conﬁgure the IP preﬁx list on ERS1.

Create a preﬁx list named Preﬁx_1 with an IP range from 10.1.240.0

to 10.1.255.0.

5530-24TFD(config)# ip prefix-list Prefix_1

10.1.240.0/20 ge 20 le 32

Conﬁgure the route policy named rip_pol_1 with match criteria

using the IP preﬁx conﬁgured in step 1. This injects one route of

10.1.240.0/20 into the route table.

5530-24TFD(config)# route-map rip_pol_1 1

5530-24TFD(config)# route-map rip_pol_1 1 enable

5530-24TFD(config)# route-map rip_pol_1 permit 1 enable

5530-24TFD(config)# route-map rip_pol_1 permit 1 match

network Prefix_1

5530-24TFD(config)# route-map rip_pol_1 permit 1

set-injectlist Prefix_1

Add the route policy created in step 2 to both RIP core ports.

5530-24TFD(config)# interface FastEthernet 2/7

5530-24TFD(config-if)# brouter vlan 2090 subnet

10.1.1.1/30

5530-24TFD(config-if)# ip rip enable

5530-24TFD(config-if)# ip rip in-policy rip_pol_1

Nortel Ethernet Routing Switch 5500 Series

Conﬁguration-IP Routing Protocols

NN47200-503 03.01 Standard

5.1 27 August 2007