Switch User Manual

IP routing configuration examples 137
MD5 configuration example
To replicate the above configuration example using the key ID 2 and key
value qwsdf89, perform the following steps:
Step Action
1
Configure MD5 authentication on R1.
5530-24TFD(config)# interface vlan 2
5530-24TFD(config-if)# ip ospf message-digest-key 2 md5
qwsdf89
5530-24TFD(config-if)# ip ospf primary-md5-key 2
5530-24TFD(config-if)# ip ospf authentication-type
message-digest
2 Configure MD5 authentication on R2.
5530-24TFD(config)# interface vlan 2
5530-24TFD(config-if)# ip ospf message-digest-key 2 md5
qwsdf89
5530-24TFD(config-if)# ip ospf primary-md5-key 2
5530-24TFD(config-if)# ip ospf authentication-type
message-digest
—End—
Configuring OSPF network types
OSPF network types were created to allow OSPF-neighboring between
routers over different types of network infrastructures. With this feature,
each interface can be configured to support the various network types.
In the example configuration illustrated below, VLAN 2 on Nortel Ethernet
Routing Switch 5500 Series R1 is configured for OSPF with the interface
type field value set as passive. Because VLAN 2 is set as passive, OSPF
hello messages are not sent on this segment, although R1 continues to
advertise this interface to the remaining OSPF network.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.