Switch User Manual

IP routing conﬁguration using the CLI 55

This command tells the router to use up to two paths to get to any

OSPF network destination.

The conﬁguration can be veriﬁed using the following command.

5530-24TFD(config)# show ecmp

—End—

IP routing conﬁguration using the CLI

This section describes the various Command Line Interface commands

available for the conﬁguration and management of IP routing. Depending

on the type of command and the context in which it is being used, these

commands are executed in the various CLI command modes.

IP conﬁguration commands

This section describes the commands for the global IP conﬁguration at

the switch level.

ip routing command

The ip routing command enables global routing at the switch level.

The syntax for the ip routing command is:

ip routing

The ip routing command is executed in the Global Conﬁguration

command mode.

no ip routing command

The no ip routing command disables IP routing.

The syntax for the no ip routing command is:

no ip routing

The no ip routing command is executed in the Global Conﬁguration

command mode.

ip blocking-mode command

Use this command to set the level of IP blocking to perform in the stack. The

syntax for this command is:

ip blocking-mode {full | none}

The following table outlines the parameters for this command.

Nortel Ethernet Routing Switch 5500 Series

Conﬁguration-IP Routing Protocols

NN47200-503 03.01 Standard

5.1 27 August 2007