Switch User Manual

62 IP Routing Conﬁguration and Management

ip route enable parameters

Parameter Description

<A.B.C.D> Enter IP address of the destination point of the route

being enabled.

<W.X.Y.Z> Enter subnet mask address of the destination node

for the route being enabled.

<O.P.Q.R> Enter the IP address of the next hop of the route

being enabled.

The ip route enable command is executed in the Global Conﬁguration

command mode.

ip route disable command

The ip route disable command disables a static route.

The syntax for the ip route disable command is:

ip route <A.B.C.D> <W.X.Y.Z> <O.P.Q.R> disable

The following table describes the parameters for this command.

ip route disable parameters

Parameter Description

<A.B.C.D> Enter IP address of the destination point of the route

being disabled.

<W.X.Y.Z> Enter subnet mask address of the destination node

for the route being disabled.

<O.P.Q.R> Enter the IP address of the next hop of the route

being disabled.

The ip route disable command is executed in the Global Conﬁguration

command mode.

traceroute command

The traceroute command displays the route taken by IP packets to a

speciﬁed host.

Note: The traceroute command, when applied to a stack, can be

executed only on the base unit.

TIP: Type CTRL+C to interrupt the command.

The syntax for the traceroute command is:

Nortel Ethernet Routing Switch 5500 Series

Conﬁguration-IP Routing Protocols

NN47200-503 03.01 Standard

5.1 27 August 2007