Switch User Manual

IP routing configuration using the CLI 63
traceroute <Hostname|A.B.C.D.|ip> <-m> <-p> <-q> <-v> <-w>
<1-1464>
The following table describes the parameters for this command.
traceroute parameters
Parameter Description
Hostname Enter the name of the remote host.
A.B.C.D. Enter the A.B.C.D. name of the remote host.
ip Enter the IP address of the remote host.
-m
Specifies the maximum time to live (ttl). The value for this
parameter is in the rage from 1-255. The default value is 10.
Example: traceroute 10.3.2.134 -m 10
-p
Specifies the base UDP port number. The value for this
parameter is in the range from 0-65535.
Example: traceroute 1.2.3.4 -p 87
-q
Specifies the number of probes per time to live. The value for
this parameter is in the range from 1-255. The default value is 3.
Example: traceroute 10.3.2.134 -q 3
-v
Specifies verbose mode.
Example: traceroute 10.3.2.134 -v
-w
Specifies the wait time per probe. The value for this parameter
is in the range from 1-255. The default value is 5 seconds.
Example: traceroute 10.3.2.134 -w 15
<1-1464>
Specifies the UDP probe packet size.
TIP: probe packet size is 40 plus specified data length in bytes.
Example: traceroute 10.3.2.134 -w 60
ip route weight command
The ip route weight command changes the weight, or cost, of a static
route.
The syntax for the ip route weight command is:
ip route <A.B.C.D> <W.X.Y.Z> <O.P.Q.R> weight <1-65535>
The following table outlines the parameters for this command.
ip route weight parameters
Parameter Description
<A.B.C.D> Enter IP address of the destination point of the route
being modified.
<W.X.Y.Z> Enter subnet mask address of the destination node
for the route being modified.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.