Switch User Manual

64 IP Routing Configuration and Management
Parameter Description
<O.P.Q.R> Enter the IP address of the next hop of the route
being modified.
<1 - 65535>
Enter the new weight, or cost, of the static route.
The ip route weight command is executed in the Global Configuration
command mode.
Address Resolution Protocol (ARP) commands
Use the CLI to display, create, configure, and remove ARP entries.
show arp command
The show arp-table command displays ARP entries.
The syntax for the show arp-table command is:
show arp-table [<A.B.C.D>]
Substitute <A.B.C.D> above with the IP address of the ARP table to be
displayed.
The show arp-table command is executed in the Global Configuration
command mode.
show ip arp command
The show ip arp command displays the IP addresses of ARP entries.
The syntax for the show ip arp command is:
show ip arp [<-s> <A.B.C.D.|W.X.Y.Z.>] [<static>]
The following table outlines the parameters for this command.
show ip arp parameters
Parameter Description
-s
Specify the subnet of the ARP entries to be
displayed.
<A.B.C.D> Specify the IP address of the ARP entry to be
displayed. This option is invalid if the switch is not in
Layer 3 mode.
<W.X.Y.Z> Enter subnet mask address in dotted decimal
notation.
static Display the software ARP table - all configured static
entries, including those without a valid route.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.