Switch User Manual

66 IP Routing Conﬁguration and Management

no ip arp command

The no ip arp command removes an ARP entry.

The syntax for the no ip arp command is:

no ip arp <A.B.C.D>

Substitute <A.B.C.D> above with the IP address of the static ARP entry to

remove.

The no ip arp command is executed in the Global Conﬁguration

command mode.

ip arp timeout command

The ip arp timeout command conﬁgures an aging time for the ARP

entries.

The syntax for the ip arp timeout command is:

ip arp timeout <5-360>

Substitute <5-360> above with the amount of time in minutes before an

ARP entry ages out. The default value is 360 minutes.

The ip arp timeout command is executed in the Global Conﬁguration

command mode.

Proxy ARP commands

This section outlines the commands used to conﬁgure and manage Proxy

ARP on the Nortel Ethernet Routing Switch 5500 Series.

ip arp-proxy command

The ip arp-proxy command is used to enable proxy ARP functionality

on the switch

The syntax of the ip arp-proxy command is:

ip arp-proxy enable

The ip arp-proxy command is executed in the Layer 3 IP VLAN Interface

Conﬁguration mode.

no ip arp-proxy command

The no ip arp-proxy command is used to disable proxy ARP

functionality on the switch.

The syntax of the no ip arp-proxy command is:

Nortel Ethernet Routing Switch 5500 Series

Conﬁguration-IP Routing Protocols

NN47200-503 03.01 Standard

5.1 27 August 2007