Switch User Manual

IP routing conﬁguration using the CLI 67

no ip arp-proxy [enable]

The no ip arp-proxy command is executed in the Layer 3 IP VLAN

Interface Conﬁguration mode.

default ip arp-proxy command

The default ip arp-proxy command is used to return the switch to the

default proxy ARP settings.

The syntax of the default ip arp-proxy command is:

default ip arp-proxy [enable]

The default ip arp-proxy command is executed in the Layer 3 IP

VLAN Interface Conﬁguration mode.

show ip arp-proxy interface command

The show ip arp-proxy interface command is used to display the

status of proxy ARP on an interface.

The syntax of the show ip arp-proxy interface command is:

show ip arp-proxy interface [vlan <vlan_id>]

The show ip arp-proxy interface command is executed in the User

EXEC mode.

Routing Information Protocol (RIP) commands

This section describes the CLI commands used to conﬁgure and manage

the Routing Information Protocol (RIP) on the Nortel Ethernet Routing

Switch 5500 Series. RIP is a distance vector protocol used to dynamically

discover network routes based on information passed between routers in

the network. RIP is useful in network environments where using static route

administration would be difﬁcult.

router rip enable command

The router rip enable command is used to globally enable RIP on

the switch. RIP must be globally enabled on the switch before it becomes

operational.

The syntax of the router rip enable command is:

router rip enable

The router rip enable command is executed in the Global

Conﬁguration command mode.

Nortel Ethernet Routing Switch 5500 Series

Conﬁguration-IP Routing Protocols

NN47200-503 03.01 Standard

5.1 27 August 2007