Switch User Manual

68 IP Routing Configuration and Management
router rip command
The router rip command is used to enter the Router Configuration
mode for RIP. Router Configuration mode is used to configure various
aspects of RIP, OSPF (router ospf command), and VRRP (router
vrrp command).
The syntax of the router rip command is:
router rip
The router rip command is executed in the Global Configuration
command mode.
network command
The network command is used to enable RIP on an IP interface.
The syntax of the network command is:
network <ip_address>
The <ip_address> parameter represents the IP address of the interface
to be configured.
The network command is executed in the Router Configuration mode.
no network command
The no network command is used to disable RIP on an IP interface.
The syntax of the no network command is:
no network <ip_address>
The <ip_address> parameter represents the IP address of the interface
to be disabled.
The no network command is executed in the Router Configuration mode.
timers basic holddown command
The timers basic holddown command is used to set the RIP holddown
timer.
The syntax of the timers basic holddown command is:
timers basic holddown <timer_value>
The <timer_value> parameter represents a value between 0 and 360
seconds.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.