Switch User Manual

IP routing configuration using the CLI 71
The ip rip cost command is executed in the Interface Configuration
mode.
ip rip default-listen command
The ip rip default-listen command is used to enable the
acceptance of default route advertisements.
The syntax of the ip rip default-listen command is:
ip rip default-listen {enable}
The ip rip default-listen command is executed in the Interface
Configuration mode.
no ip rip default-listen command
The no ip rip default-listen command is used to disable the
acceptance of default route advertisements.
The syntax of the no ip rip default-listen command is:
no ip rip default-listen {enable}
The no ip rip default-listen command is executed in the Interface
Configuration mode.
ip rip default-supply command
The ip rip default-supply command is used to enable the
advertisement of default routes on the interface.
The syntax of the ip rip default-supply command is:
ip rip default-supply {enable}
The ip rip default-supply command is executed in the Interface
Configuration mode.
no ip rip default-supply command
The no ip rip default-supply command is used to disable the
advertisement of default routes on the interface.
The syntax of the no ip rip default-supply command is:
no ip rip default-supply {enable}
The no ip rip default-supply command is executed in the Interface
Configuration mode.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.