Switch User Manual

76 IP Routing Configuration and Management
The no ip rip supply command is executed in the Interface
Configuration mode.
ip rip timeout command
The ip rip timeout command is used to set the RIP timeout value
on this interface.
The syntax of the ip rip timeout command is:
ip rip timeout <timer_value>
The <timer_value> parameter is an integer value between 15 and
259200 seconds.
The default timeout value is 180 seconds.
The command is executed in the Interface Configuration mode.
ip rip triggered command
The ip rip triggered command is used to enable triggered updates
on this RIP interface.
The syntax of the ip rip triggered command is:
ip rip triggered {enable}
The ip rip triggered command is executed in the Interface
Configuration mode.
no ip rip triggered command
The no ip rip triggered command is used to disable triggered
updates on this RIP interface.
The syntax of the no ip rip triggered command is:
no ip rip triggered {enable}
The no ip rip triggered command is executed in the Interface
Configuration mode.
show ip rip command
The show ip rip command is used to display configuration and statistical
information about RIP.
The syntax of the show ip rip command is:
show ip rip [interface]
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.