Switch User Manual

82 IP Routing Conﬁguration and Management

default ip rip timeout command

The default ip rip timeout command is used to restore the default

RIP timeout setting for the interface.

The syntax of the default ip rip timeout command is:

default ip rip timeout

The default ip rip timeout command is executed in the Interface

Conﬁguration mode.

default ip rip triggered command

The default ip rip triggered command is used disabled triggered

updates on this switch.

The syntax of the default ip rip triggered command is:

default ip rip triggered enable

The default ip rip triggered command is executed in the Interface

Conﬁguration mode.

Open Shortest Path First (OSPF) commands

This section describes the CLI commands used to conﬁgure and manage

the Open Shortest Path First (OSPF) protocol on the Nortel Ethernet

Routing Switch 5500 Series. The Open Shortest Path First (OSPF) Protocol

is an Interior Gateway Protocol (IGP) that distributes routing information

between routers belonging to a single autonomous system (AS). Intended

for use in large networks, OSPF is a link-state protocol which supports IP

subnetting and the tagging of externally-derived routing information.

Note: OSPF commands used during the conﬁguration and management

of VLANs in the Interface Conﬁguration mode can be used to conﬁgure

any VLAN regardless of the one used to log into the command mode.

Insert the keyword vlan with the number of the VLAN to be conﬁgured

after the command keywords ip ospf. The current VLAN will remain at

the one used to log into the Interface Conﬁguration command mode

after the command execution.

ip ospf apply accept command

The ip ospf apply accept command is used to apply OSPF accept

policies to the switch.

The syntax of the ip ospf apply accept command is:

ip ospf apply accept

Nortel Ethernet Routing Switch 5500 Series

Conﬁguration-IP Routing Protocols

NN47200-503 03.01 Standard

5.1 27 August 2007