Switch User Manual

IP routing configuration using the CLI 95
no area virtual-link message-digest-key <A.B.C.D.> <W.X.Y.Z>
<1-255>
no area virtual-link message-digest-key command parameters
Parameter Description
<A.B.C.D.> Specifies the transit area ID expressed as an IP address.
<W.X.Y.Z> Specifies the neighbor router ID expressed as an IP
address.
<1-255>
Specifies the primary MD5 key value, expressed as an
integer from 1-255.
The no area virtual-link message-digest-key command is
executed in the Router Configuration mode.
auto-vlink command
Use the auto-vlink command to enable global automatic Virtual Link creation.
For more information about Virtual Link, see "OSPF virtual link" (page 31)
The syntax for the auto-vlink command is:
auto-vlink
The auto-vlink command is executed in the Router Configuration mode.
no auto-vlink command
Use the no auto-vlink command to disable global automatic Virtual
Link creation.
The syntax for the no auto-vlink command is:
no auto-vlink
The no auto-vlink command is executed in the Router Configuration
mode.
ip ospf advertise-when-down command
The ip ospf advertise-when-down command is used to enable
advertisement of the OSPF interface even when the interface is operationally
unavailable.
The syntax of the ip ospf advertise-when-down command is:
ip ospf advertise-when-down enable
The ip ospf advertise-when-down command is executed in the
Interface Configuration mode.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.