Switch User Manual

Configuring APs 345
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Displaying active connection information for APs
A AP can have only one active data connection. To display the system IP address of the WSS that has the active connec-
tion (the switch that booted the AP), use the following command:
show ap connection [ap-num | serial-id serial-ID]
The serial-id parameter displays the active connection for a Distributed AP even if that AP is not configured on this
WSS. However, if you use the command with the ap-num parameter or without a parameter, connection information is
displayed only for APs that are configured on this WSS.
This command provides information only if the AP is configured on the switch where you use the command. The switch
does not need to be the one that booted the AP, but it must have the AP in its configuration. Also, the switch that booted
the AP must be in the same Mobility Domain as the switch where you use the command.