Switch User Manual

Configuring APs to be AeroScout listeners 405
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Using an AeroScout engine
1 Load the site map in AeroScout System Manager.
2 Mark the origin point (0,0), if not already done.
3 Calibrate distance, if not already done.
4 Add each AP configured as a listener to the map, and enter its IP address.
5 Enable RSSI location calculation.
6 Enable tag positioning.
7 Enable the map to use the APs.
To check an AP’s status, right-click on the AP icon and select Status.
Note. To look up a AP’s IP address, use the show ap status command.