User's Manual

Chapter 2 Documentation updates for BCM 4.0 17
BCM 4.0 for BCM1000 Installation and Maintenance Guide Addendum
In Tables 37 and 38 on page 145 and 146 respectively, the references to PDD should be deleted.
Pages 160–161, New chapters
The following chapters should be inserted between Chapter 13, “Installing optional telephony
equipment” and Chapter 14, “Troubleshooting.” These chapters are located at the back of this
addendum (the chapters should be viewed in the order given):
• “Initializing the system” on page 29
• “Configuring the BCM system” on page 35
• “Using Telset Administration to set the basic parameters” on page 39
• “Using Element Manager to set the basic parameters” on page 45
• “Completing the initial installation (optional)” on page 57
Pages 168–169, Shutting down the system software and
Shutting down the system hardware
These sections should be replaced with the information in this section,“Page 110, Shutting down
the system” on page 15.
Page 171, Software restart
This procedure should be changed to:
If you did not shut down the system, restart the software:
1 In Element Manager, from the Administration tab, click the Utilities folder to expand it.
2 From the Utilities folder, select Reset.
3 Click Reboot BCM System to reboot the system.
Page 179, Initializing the hard disk (single-disk system BCM
2.5/2.5.1)
This section should be removed.
Warning: When you restart the system, all IP clients, voice mail, and VoIP ports
are not available until the system services restart.
If you have a mirrored disk system, once the services restart, the system
automatically ensures the mirrored disk is updated.