User's Manual

20 Chapter 2 Documentation updates for BCM 4.0
N0060603N0060603
Page 229, Determining the status of a telephone
The procedure, “To find out the status of a set,” should be modified as follows.
To find out the status of a set
1 Open Element Manager and connect to your BCM system.
2 From the Configuration tab, click the Telephony folder to expand it.
3 From the Telephony folder, select Sets.
4 From the Sets subfolder, select Active Sets.
5 In the Active Sets panel, select the desired telephone.
6 Use the various tabs and the Details panel to view the status of the telephone.
Page 230, Moving telephones
The sentence, “You can move a Business Communications Manager digital telephone to a new
location within the system without losing its programmed settings if the telephone has been
enabled with Set relocation in system programming under Feature programming,”
should be, “You can move a BCM digital telephone to a new location within the system without
losing its programmed settings if the system has been enabled with Set relocation (Configuration
> Telephony > Global Settings > Feature Settings).”
Page 233, Appendix A, Defining region-based defaults
This appendix should be removed and replaced with the chapter, “Market profile attributes” on
page 61.
Page 254, Set DNs and port numbers
In Table 64 on page 254, the references to PDD should be deleted.