User's Manual

42 Appendix D Using Telset Administration to set the basic parameters
N0060603N0060603
To select the telephony startup template and start DN
You set the template and start DN using Feature **STARTUP from a two-line display telephone.
Refer to the BCM 4.0 Telset Administration Guide for information on using Telset Administration
to set this parameter.
Other telephony startup parameters are configured using Feature **CONFIG. Refer to the BCM
4.0 Telset Administration Guide for more information.
To initialize voice mail
You initialize your voice mail system using Feature 983 from a two-line display telephone.
Refer to the CallPilot Telephone Administation Guide for information on using Telset
Administration to initialize your voice mail system.
To create Telset user accounts
1 Select Feature 9*8 from a two-line display telephone.
2 Enter the following user ID and password:
User ID: SETNNA
Password: CONFIG
The numerical values of the user ID and password are 738662 and 266344, respectively.
3 Press NEXT to scroll through the menu and select User Accounts.
4 Press OK. The Accounts screen appears.
5 Press NEXT to scroll through the list of available accounts to create.
6 Press CHNGE to change the status of the current account.
7 Press CRT to create the account.
If you see the DEL command instead of the CRT command, then the account is already
created.
8 Press BACK. The Accounts screen appears.
9 Press NEXT. The password screen appears.
10 Press CHNGE to change the password.
11 Press NEXT to scroll through the list of available accounts.
Note: You can only set these parameters for only 15 minutes after system bootup.
Note: You can only create Telset accounts using Telset Administration. To
create Element Manager accounts, you must use Element Manager.