User's Manual

48 Appendix E Using Element Manager to set the basic parameters
N0060603N0060603
To configure the LAN IP address
1 From the Configuration tab, click the Resources folder to expand it.
2 Select Network Interfaces.
3 Select the Interfaces tab. It is normally selected by default.
4 Select the LAN interface to configure.
5 From the Details panel, select the IP Settings tab.
6 From the IP Address Specification area, click Modify. The Modify IP Settings dialog box
opens.
7 Configure the IP Settings attributes (see Table 6).
8 Click Ok.
To configure the modem
1 From the Configuration tab, click the Resources folder to expand it.
2 Select Network Interfaces.
3 Select the Global Settings tab.
4 Select the regional profile from the Modem Region dropdown list for your region.
5 Select the Enable modem checkbox to enable the modem.
For more information on modem configuration, refer to the BCM 4.0 Networking
Configuration Guide.
Table 6 Modify IP Settings attributes
Attribute Description
Obtain IP address dynamically If this is selected, the BCM system attempts to take IP address
information from a DHCP server.
If this is not selected, you must enter values for static IP address, IP
subnet mask, and Default gateway.
IP address The IP address of the BCM system.
IP subnet mask The subnet mask used by the BCM system.
Note: If any of the attributes are modified, then the Element Manager session is disconnected.