Manualshelf

Product Manual

ManualsBrandsNorth American Signal ManualsLED Specialty LightingSurface Mount Warning Light
1
RECOMMENDED
MOUNTING INSTRUCTIONS
INSTALLATION
:
1. Locate a flat surface on vehicle and confirm adequate space is available
LED3000/1 requires 4” x 1.75“
2. Use center-punch if available to start 2 mounting holes and 1 wire exit hole for the 3000/1.
Drill 7/64” mounting holes and 3/8” hole/s for wire exit -
USE THE GASKET PROVIDED AS A TEMPLATE
4. Insert wire through center hole and position mounting screws in holes.4. Insert wire through center hole and position mounting screws in holes.
5. Connect red wire to power (+) with optional 3A fuse (not provided), and black wire to ground (-)
6. Use screws provided to secure LED lamp into position
OPERATION:
1. To select flash pattern touch yellow wire exiting the rear of the unit to red wire 12V (+)
a. Hold for less than one second to move to next pattern
b. Hold for more than one second to move to previous pattern
c. Hold for more than 5 seconds to reset to default (# 1 on carton list)
d. See list below for available patterns
2. For sychronized flash patterns
a. establish the same pattern on both units (recommended)
b. connect the two yellow wires. (Note: lightheads will not sync on random pattern)
3. For alternating flash patterns
a. establish the same pattern on both units (recommended)
b. connect the two yellow wires
c. connect one white wire to power 12V (+) from one of the light heads for alternating display
d. for alternating groups of heads one white wire from each light in the group goes to red 12V (+)
LED3000-X
FLASH PATTERNS:
0 - Random (Default)
1 - Single (Split)
2 - Double (Split)
3 - Quad (Split)
4 - Quint (Split)
5 - Mega (Split)5 - Mega (Split)
6 - Ultra (Split)
7 - Single-Quad (Split)
8 - Single H/L (Split)
9 - Single (All)
10 - Double (All)
11 - Quad (All)
12 - Quint (All)
13 - Mega (All)
14 - Ultra (All)
15 - Single-Quad (All)15 - Single-Quad (All)
16 - Single H/L (All)
17 - Steady 2 (California)
18 - Steady 4 (All)
For Light Series - LED3000/LED3001
***Proper installation of this product is the sole responsibility of the installer***

Summary of content (1 pages)