MODEL: NSD1 0005 PACKING DIAGRAM S1YROFOAM: 16 KGS.
You should have received the following parts in the package. Please ensure that all parts are accounted for.
Care and Instruction Manual
NSD10005 ASSEMBLY INSTRUCTIONS Please reference the separate parts list and ensure that all pieces are included in the package prior to assembly. To protect the finish, place all parts on a soft surface when unpacking. When assembling ensure that all parts are firmly tightened. Choose a location: This freestanding water feature is attractive from all sides and can be used to highlight almost any area. This water feature is designed for outdoor use. It can be used indoors, however splashing may occur.
NSD10005 ASSEMBLY INSTRUCTIONS Place reservoir (B) onto top of the base (A). B A Feed light power cord (G) then pump power cord (E) through plastic tube. Cords should exit through notch in bottom of base (A).
NSD10005 ASSEMBLY INSTRUCTIONS Place pole (C) into reservoir (B). C B Attach pump (E) to the rubber hose. Place lights (G) into light holders on the bottom of column (D).
NSD10005 ASSEMBLY INSTRUCTIONS Put column (D) onto top of the pole (C). D C FINAL STEPS Fill reservoir (B) with distilled water. Water level should stay above fill line on the pole (C) when fountain is running. Connect the light connectors (F) and (G) and screw the cap tightly. 7 Plug light transformer (F) and pump (E) into outlets and turn light on at switch. Use shims (H) to level the fountain as necessary. Note: Light does not have to be on to operate pump.
NSD10005 ASSEMBLY INSTRUCTIONS PUMP SAFETY & TROUBLESHOOTING To clean the pump Unplug the pump from the electrical outlet. Use a small soft brush or place it under a water stream to remove debris. To keep water clean Periodically change water to prevent algae buildup. Tube Rotor/Impeller Impeller cover Back cover Regulator Pump housing Filter/ Front cover Suction cup If the pump fails to run: • Check circuit breaker, or try a different outlet. • Check tubing for kinks and obstructions.
NSD10005 ASSEMBLY INSTRUCTIONS WATER FEATURE WARNINGS & TROUBLESHOOTING • Splashing may occur when the fountain is first turned on, protect surrounding surfaces as needed. Do not place the water feature on or near any surface that can be damaged by water. • Distilled water is recommended to reduce mineral deposits, bacteria build up and algae that may damage the water feature basin and pump. • To reduce the risk of electrical shock, always disconnect the power supply before working with the water feature.
NSD10005 ASSEMBLY INSTRUCTIONS FREQUENTLY ASKED QUESTIONS What should I consider when selecting a water feature? In addition to your personal style tastes, be sure you have an area for your water feature that can be safely exposed to water, as splashing can occur. Also take into consideration what a water feature can add to your environment: the sound of flowing water or decorative lights.
NSD10005 ASSEMBLY INSTRUCTIONS FREQUENTLY ASKED QUESTIONS CONTINUED How much water do I need to keep in the water feature? Where possible in our water features, we have included fill lines to help you visualize the water level required for proper function. If your water feature does not include fill lines, please check the instruction manual for water capacity.
NSD10005 ASSEMBLY INSTRUCTIONS FREQUENTLY ASKED QUESTIONS CONTINUED How do I change my pump speed? Depending on the type of pump, you will need to either move the slider or turn the knob. Flow control valve Maximum Minimum How do I clean my pump? 1. Disconnect the power supply and then remove pump cover/filter. 2. Gently pull impeller/rotor assembly out of the pump housing 3. Rinse the impeller/rotor assembly and the cavity with clean water. 4.