User Guide
Table Of Contents
- APPLICABILITY TABLE
- CONTENTS
- 1. Introduction
- 2. General Product Description
- 3. PINS ALLOCATION
- 4. Power Supply
- 5. DIGITAl SECTION
- 6. RF SECTION
- 7. AUDIO SECTION
- 8. GNSS Section
- 9. Mechanical Design
- 10. APPLICATION PCB Design
- 11. PACKAGING
- 12. Conformity Assessment Issues
- 13. PRODUCT AND SAFETY INFORMATION
- 14. GLOSSARY
- 15. Document History
ME910G1 Hardware Design Guide
1VV0301593 Rev.15 Page
39 of 100 2022-08-23
Not Subject to NDA
A flow chart showing the AT commands managing procedure is displayed below:
Figure 7: AT commands managing procedure flow chart
Note
: To avoid a back powering it is recommended to prevent any
HIGH logic level signal from being applied to the digital pins of the
ME910G1 when the module is powered off or during an ON-OFF
transition.
“Start AT CMD”
START
Delay = 300 msec
Enter AT <CR>
GO TO
“HW Shutdown
Unconditional”
AT answer in
1 sec ?
GO TO
“Modem ON Proc.”
“Start AT CMD”
END
Y
N