User manual

Northern Industrial Welding
2
Operating Instructions and Parts Manual
ST80i
Specifications and Dimension
MODEL ST80i
Power supply (v) 1ph-120V-60HZ
No-load voltage (v) 75V
Output Range (A) 20-75A 90A Peak
Duty cycle (%) 20% @75A
Suggested electrode E6013,E7014,E7018, Stainless steel
Electrode Diameter (Inch)
1/16”, 5/64”, 3/32”（1.6mm，2.0mm，2.4mm）
Dimensions
Length x Width x Height
300x120x240MM / 12x5x9 inches
Weight (Ibs) 4.5Kgs 9.9Lbs
Know your Welder
Indicating Light（Power, Thermal Protection）
There are two indicating lights : power indicator and thermal indicator. When the
machine is turned on, the power indicator will be on to show it. When the thermal
indictor is on, it shows the machine is overloaded working and the internal
temperature is too high. The machine will turn off automatically but the fan will
still be working. When the internal temperature is decreased, the machine will
turn on automatically.
Current Adjustment
Current adjustment is on the front panel of machine. It is an infinite current output
adjustment
Output “+“Connector
This is the connector for welding cable most often when STICK welding. When
this machine is used for TIG welding, this connector is for the grounding cable.
Ground Cable and Clamp
The ground cable and clamp is attached to the work piece to complete the flow of
current needed to weld.
MAX/MIN
Switch
Ground Ca
b
Thermal Indi
c
Power Indicating light
Welding cable and
electrode holder
Current adjustment
Output“+”connector
Ground Cable
and clam
p
Strap
Thermal protection
Indicatin
g
li
g
ht
Output“-”connector