User manual

Northern Industrial Welding
5
Operating Instructions and Parts Manual
ST80i
connections are a hazard, so secure
the ground lead before welding.
-Wear dry protective apparel: coat,
shirt, gloves and insulated footwear.
-Insulate yourself from the work piece.
Avoid contacting the work piece or
ground.
- Do not attempt to repair or maintain
the welder while the power is on.
-Inspect all cables and cords for any
exposed wire and replace
immediately.
-Use recommended replacement
cables and cords.
-Always attach ground clamp to the
work piece work table as close to the
weld area as possible.
-Do not touch the electrode and the
ground or grounded work piece at the
same time.
-Do not use a welder to thaw frozen
pipes.
Fumes and Gases
-Fumes emitted from the
welding process displace
clean air and can result in
injury or death.
-Do not breathe in fumes emitted by
the welding process. Make sure your
breathing air is clean and safe.
-Work only in a well-ventilated area or
use a ventilation device to remove
welding fumes from the environment
where you will be working.
-Do not weld on coated materials
(galvanized, cadmium plated or
containing zinc, mercury or barium).
They will emit harmful fumes that are
dangerous to breathe. If necessary
use a ventilator, respirator with air
supply or remove the coating from the
material in the weld area.
-The fumes emitted from some
metals when heated are extremely
toxic. Refer to the material safety
data sheet for the manufacturer’s
instructions.
-Do not weld near materials that will
emit toxic fumes when heated.
Vapors from cleaners, sprays and
degreasers can be highly toxic when
heated.
UV and IR Arc Rays
The welding arc
produces ultraviolet (UV)
and infrared (IR) rays
that can cause injury to your eyes
and skin. Do not look at the welding
arc without proper eye protection.
-Always use a helmet that covers
your full face from the neck to top of
head and to the back of each ear.
-Use a lens that meets ANSI
standards and safety glasses. For
welders under 160 Amps output, use
a shade 10 lens; for above 160 Amps,
use a shade 12. Refer to the ANSI
standard Z87.1 for more information.
-Cover all bare skin areas exposed to
the arc with protective clothing and
shoes. Flame-retardant cloth or
leather shirts, coats, pants or
coveralls are available for protection.
-Use screens or other barriers to
protect other people from the arc rays
emitted from your welding.
-Warn people in your welding area
when you are going to strike an arc
so they can protect themselves.
Fire Hazards
Do not weld on containers
or pipes that contain or
have had flammable,
gaseous or liquid combustibles in
them. Welding creates sparks and
heat that can ignite flammable and