Product Manual

Table Of Contents

Initial Set-Up

Step 2. Assembly of Pressure Washer

Note: Remove contents from pallet and assembly can

occur at this time or in conjunction with Step 4

Install Pressure Washer Handle

1. Insert Grommets into Billboard. Nozzles can

be inserted into Grommets. An extra Grommet

has been provided for an extra Nozzle.

2. Fasten Handle to Frame using:

• (2) 5/16″ x 2″ Carriage Bolts (82233)

• (2) T-handle knobs (38578)

Note: Repeat for both sides of handle

3. Install Billboard to handle using (4) screws

(87170)

Spray Gun Assembly

4. Attach the Lance to Spray Gun

• Tighten spin-on coupler hand tight

Note: The o-rings make the seal so there is no need to

tighten with a wrench.

Connect High Pressure Hose

Step 3. Select Suitable Location

Moving your pressure washer around

• Use the handle to manually move the pressure

washer.

• Push the pressure washer in front of you has

you walk.

• To turn, push down slightly on the handle and

pivot the pressure washer on its back wheels.

WARNING: Lifting hazard

The pressures washer is heavy. It can crush and cause

serious injury if it rolls out of control or tips over. Follow

the instructions below for safely moving the pressure

washer.

WARNING: Location hazards

Choose a suitable site for operating your pressure

washer to prevent possible death from carbon

monoxide poisoning or injury from fire/explosion, hot

surfaces or equipment tip-over.

Lance

Spin-On Coupler

157134 & 157136