Manual

Hazard Signal Word Definitions
2 | P a g e
Any Questions, Comments, Problems, or Parts Orders
Call NorthStar ProSHOT Product Support 1-800-969-7073
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that
follow this symbol to avoid injury or death.
DANGER
DANGER indicates a hazardous situation, which if not avoided, will result in death or serious injury.
WARNING
WARNING indicates a hazardous situation, which if not avoided, could result in death or serious injury.
CAUTION used with the safety alert symbol, indicates a hazardous situation, which if not avoided, could result in minor or
moderate injury.
CAUTION
CAUTION
CAUTION without the safety alert symbol, is used to address practices not related to personal injury.
NOTICE
NOTICE is used to address practices not related to personal injury.
EQUIPMENT PROTECTION QUICK FACTS
Inspect Upon
Delivery
STOP! Thoroughly inspect to make sure no components are missing or damaged. See the Assembly and Initial Set-Up
section for instructions on whom to contact to report missing or damaged parts.
Check Engine Oil
Engine is shipped with oil. Check the engine oil level before starting the pressure washer.
Check Pump Oil
Pump is shipped with oil. Check the pumps oil level before starting.
Battery Required
A battery is included, but not connected. The engine will not run unless the battery is connected. If replacing, purchase a
12 Volt, minimum 24 Amp/Hr. standard top post mount automotive (Group 75/86).
Water Flow
Requirements
Make sure your supply water flow rate is 20% higher than the pressure washer's flow rate (see Specifications section for
detail), and that your water is clean and particle free.
Storage
Do not allow water to freeze in the pump, hose, coil, or spray gun(s).
Chemical
Spraying
Use only NorthStar brand or equivalent pressure washer chemicals designed for high-pressure washer use. Use soap
adjustment knob to regulate cleaning power if applicable.
Maintenance
Schedule
Engine:
• See Engine’s Owner's manual.
Pump:
• Change oil after first 40 hours, then every 3 months or 500 hours.
Burner Fuel Filter /Water
Separator:
• Drain water as needed.
• Change filter after every 500 hours of use.
Coil:
• Descale coil annually or more frequently as conditions/performance
require.
• Inspect coil for soot build-up annually and desoot if needed.
Electrodes:
• Inspect electrodes annually and clean/adjust as needed.
Belts:
• Check belt tension after the first 24 hours of use, then routinely with each oil
change. Tighten or change belts as needed.