Product Manual

Assembly

Step Four: Check and test completed assembly

WARNING

Check and test completed assembly

Serious injury could result from chemical leaks if sprayer is improperly assembled or

the design of the sprayer is modified.

Follow the steps below to make sure the sprayer is properly assembled. Never modify

the sprayer design.

1. Check assembly

Check assembly to make sure the sprayer is properly assembled and in

safe working condition:

a) Check that the gun clip screws are tight, hose clamps are secure, and tank

straps are properly fastened.

b) While it is unlikely that factory assembled components become loose, they

should also be checked to make sure they are tight.

2. Fill tank with

water

Test the system for leaks with water:

a) First read the instructions in this Owner’s Manual for Operation of the

sprayer.

b) Add fuel to the engine per the instructions in this manual.

c) Fill the tank with water per the instructions in this manual. Important: The

sprayer should NOT be running when you fill the tank.

d) Check for leaks throughout the system by operating the sprayer per the

instructions in this manual:

i) Turn the sprayer ON. (See Operation Instructions)

ii) With agitation and spray gun valves closed, adjust the pressure

through its full range – to maximum and back. (See Operation

Instructions)

iii) Open the agitation valve to initiate agitation. (See Operation

Instructions)

iv) Operate the spray gun. (See Operation Instructions)

e) If a leak is detected, fix the leak and re-test the system with water.