Product Manual

Page 8 of 13
⚠CAUTION
Do not extend or retract your extension wand while spraying or while under pressure. Stop the
equipment and relieve any pressure before making adjustments to the extension wand or changing
nozzles.
To Extend the Wand
Loosen the lock rings and pull the wand out to the desired length. Re-tighten the lock rings to hold the
wand at the desired length.
To Retract the Wand
Loosen the lock rings and slide the extension segment into the wand until the desired length is
reached. Re-tighten the lock rings to hold the extension segments in place.
To Begin Spraying
Start the sprayer. Raise the wand and keep the nozzle at least ten feet away from the surface to be
cleaned. Squeeze the trigger to begin spraying, maintain stable footing, and move the wand in to the
surface to be cleaned.
⚠CAUTION
Except in cases of emergency, do not release the trigger near any surfaces.
To Stop Spraying
Before releasing the trigger gun, move the nozzle at least ten feet away from the surface being
cleaned and make sure you have solid footing. The wand will rebound when the trigger is released or
if pressure is lost. When you are clear of the work surface and in a safe area, release the trigger.
⚠CAUTION
USE EXTREME CAUTION when working on or near fragile surfaces, as there may be enough force
to damage surfaces or break windows. Keep clear of power lines.
After Each Use
⚠WARNING
Relieve pressure before disconnecting gun from pump hose.
Clear the wand of water, fully retract, and store in dry place.