Product Manual

Assembly
17
Step 7: Connect remote switch to vehicle battery.
1. Preparatory safety
Preparatory safety steps:
• ALWAYS use eye protection.
• NEVER smoke or work near sparks or other sources of ignition.
• NEVER touch both battery terminals at the same time or with any
non-insulated tools.
• If battery acid contacts skin or clothing, flush immediately with
water and neutralize with baking soda.
2. Connect remote
switch to battery
Connect the sprayer’s remote switch to the vehicle battery using the
following procedure:
a) Disconnect the vehicle battery ground wire.
b) Connect the remote switch’s red battery clamp to the positive (+)
terminal of the battery.
c) Connect the remote switch’s black battery clamp to the negative (-)
terminal of the battery.
d) Reconnect the vehicle battery ground wire.
WARNING: Always connect in this sequence to avoid possible shock.
3. Connect remote
switch to pump
power cord
Connect the remote switch to the pump power cord:
Note: Make sure the power switch is in the OFF position on the remote
switch.
4. Verify connection
Verify a complete connection has been made by checking with a DC
voltmeter, or by briefly turning the remote switch to the ON position and
listening for pump activation.
5. Attach remote
switch to vehicle
Using supplied Hook & Loop pad, affix remote switch to vehicle in a
position that is easily reached from the driver's seat.
WARNING
Batteries are hazardous because they contain caustic acid, can emit explosive gases, and
can cause electric shock.
Caution must be exercised when making connections to a battery to avoid shock and
contact with the acid, and to prevent any sparking that could lead to an explosion.
ALWAYS follow the safety instructions and steps listed below in exact sequence when
connecting the sprayer’s remote switch to the battery terminals.
Remote switch
Pump power plug
Fig06401