Product Manual

Machine Components (Model 99918, 99919, 99920, 99921)
19
1. Hose Wrap. The hose wrap provides a storage location for the gun hose.
2. Gun Hose. The gun hose transfers chemical from the pump to the spray gun.
3. Fill Cap. The fill cap has a vent to allow air to enter the tank as the chemical is
dispensed.
4. Sprayer Pump. The sprayer pump makes the chemical flow to the spray gun and out
the nozzle.
5. Drain Cap. Remove the drain cap to empty the tank. Dispose of or store remaining
chemicals properly as recommended on the chemical label.
6. Spray Gun. Use the spray gun to apply chemical to specific areas. The spray pattern is
adjustable from stream to cone by twisting the spray nozzle (see Operation Instructions).
When the remote switch is in the ON position, the spray gun trigger is the pump
ON/OFF control. Squeeze the trigger and the pump turns on, let go and the pump turns
off.
7. Gun Clips. Use the gun clips to store the spot spray gun.
8. Sprayer Tank. The sprayer tank holds the chemical.
9. Pump Power Plug. Connect the remote switch to the sprayer pump at this location. It
should be disconnected when the sprayer is not in use.
10. Remote Switch. The remote switch connects the battery to the pump power plug and
allows the operator to turn the sprayer pump on and off. The remote switch may be left
connected to the battery when the sprayer is not in use.
11. Spray Nozzle. Spraying pattern adjusts from stream to cone.
12. Handles. Bolt on handles for carrying empty sprayer.
13. Suction Strainer. Suction strainer has clear removable bowl for easy cleaning.
14. Regulator. This controls system pressure.
15. Fill marks. Molded into tank.
Fig06402