Product Manual

Operation – Preparing the Sprayer for Each Use
24
If the sprayer has been used previously, it must be prepared BEFORE EACH SUBSEQUENT USE.
WARNING
• Read instructions below carefully for inspecting and preparing the sprayer.
• Damaged or clogged equipment could result in leaks or uncontrolled spray.
• Leaks could result in injury to the operator or bystanders from chemical exposure,
or cause damage to the environment.
Important safety rules:
• Power off. Make sure all power is OFF before cleaning, inspecting, or servicing the sprayer.
• Guards / shields. Make sure all guards and shields are replaced after servicing the sprayer.
• Replacement parts. If a part needs replacement, only use parts that meet the manufacturer’s
specifications. Replacement parts that do not meet specifications may result in a safety
hazard or poor operation of the sprayer.
1. Ensure sprayer
attached
Ensure the sprayer is securely attached to the vehicle.
2. Ensure tank
empty
Ensure the sprayer has been thoroughly flushed and drained of all
residual chemical from prior uses.
3. Clean suction
strainer
Clean the suction strainer of any chemical residue.
It is important to clean
the suction strainer
before each use to
ensure it is not clogged
and to prevent residual
chemical from
contaminating sprayer
contents.
a.) USING RUBBER
GLOVES, remove
clear strainer bowl.
b.) Run the screen under
fresh water to remove debris.
c.) Replace the suction strainer
bowl.
4. Inspect &
repair
Inspect and test the sprayer thoroughly:
a) Inspect hoses for exposed mesh and holes. Replace all worn or
damaged hoses.
b) Inspect tank and fittings for cracks and leaks. Replace all damaged
fittings with original Northstar Product Support parts.
c) Check to be sure retaining nut on gun nozzle is tight.
d) Check to be sure all other nuts, bolts, and screws are tight.
e) Check wheels and tires, if equipped. Make sure wheel lugs are tight
and tires are inflated.
f) Partially fill tank with plain water and spray to test for leaks. Repair as
needed.
IMPORTANT: After any repair work has been done, ALWAYS test for
leaks with water one final time before using.
Suction
strainer
(Inside
tank)
Fill cap
Fig06403
Bowl
Screen
Body
Suction strainer
Exploded view