Product Manual

Operation – Using the Sprayer (continued)
27
Step 3: Operate the sprayer.
WARNING
• ALWAYS wear personal protective equipment as directed on the chemical label when
spraying.
• Long pants and sleeves, chemical-resistant gloves, and eye protection are strongly
recommended. Additional protective gear may be required depending on the particular
pesticide.
1. Review safety
information
Review the Operation – Important Safety Information related to
Chemical Application Safety and ATV Vehicle Handling Safety provided
in this manual.
2. Wear personal
protective
equipment
Wear personal protective equipment as directed on the chemical label.
3. Turn on power
Turn on the power to the sprayer.
1. Verify the remote switch is connected to the pump power cord.
2. Turn the remote switch to the “ON” position.
Note: The pump will start automatically when power is turned on. The
pump will cycle on and off as needed to retain pressure in the hose.
4. Squeeze trigger
& adjust
nozzle
To spray, squeeze the gun trigger.
- Twist the spray nozzle to adjust from a straight stream to hollow
cone spray pattern, as recommended on the chemical label for
proper delivery rate.
Note: It is not unusual for the operator to be exposed to chemical drips
while adjusting the nozzle – gloves should be chemical resistant.
5. Adjust
pressure
regulator
Turn pressure regulator knob to adjust outlet pressure
1. Turn knob clockwise to increase pressure.
2. Turn knob counter-clockwise to decrease pressure
Note: If the pressure regulator knob is completely tightened, the
pressure setting will be higher than the pressure switch on the pump.
This allows the pump to operate as a demand pump and turn on only
when spraying.
Retaining nut
Spray Nozzle
Fluid bypass
Pressure Gauge
Pressure
regulator knob