Product Manual

Operation – Using the Sprayer (continued)

C. Ensure correct spray pattern

Rotate the broadcast nozzle, if needed, so that the spray pattern is pointed

down and evenly distributed. The screw on the front of the nozzle should be

at the 12 o'clock position.

D. Begin to spray

Turn the power ON, turn broadcast lance valve to the on position.

E. Adjust pressure regulator

Turn pressure regulator knob to adjust outlet pressure

1. Turn knob clockwise to increase pressure.

2. Turn knob counter-clockwise to decrease pressure

Note: If the pressure regulator knob is completely tightened, the

pressure setting will be higher than the pressure switch on the pump.

This allows the pump to operate as a demand pump and turn on only

when spraying.

On position

Note: It is not unusual for the

operator to be exposed to chemical

drips while adjusting the broadcast

nozzle. Wear chemical resistant

gloves.

Screw should be

at 12 o'clock position.

use a 7/8" wrench to

make adjustments.

Pressure

regulator knob

Pressure gauge

Fluid bypass