Product Manual

Operation – Using the Sprayer (continued)
29
Step 3: Operate the sprayer. (Models 99905 and 99906)
WARNING
• ALWAYS wear personal protective equipment as directed on the chemical label when
spraying.
• Long pants and sleeves, chemical-resistant gloves, and eye protection are strongly
recommended. Additional protective gear may be required depending on the particular
pesticide.
1. Review safety
information
Review the “Operation – Important Safety Information” related to
Chemical Application Safety and ATV Vehicle Handling Safety provided in
this manual.
2. Wear personal
protective
equipment
Wear personal protective equipment as directed on the chemical label.
3. Turn on power
Turn on the power to the sprayer.
1. Verify the remote switch is connected to the pump power cord.
2. Turn the remote switch to the “ON” position.
Note: The pump will start automatically when power is turned on. The
pump will cycle on and off as needed to retain pressure in the hose.
4. Squeeze trigger
& adjust
nozzle
To spray, squeeze the gun trigger.
- Twist the spray nozzle to adjust from a straight stream to hollow
cone spray pattern, as recommended on the chemical label for proper
delivery rate.
Note: It is not unusual for the operator to be exposed to chemical drips
while adjusting the nozzle – gloves should be chemical resistant.
5. Adjust
pressure
regulator
Turn pressure regulator knob to adjust outlet pressure
1. Turn knob clockwise to increase pressure.
2. Turn knob counter-clockwise to decrease pressure
Note: If the pressure regulator knob is completely tightened, the pressure
setting will be higher than the pressure switch on the pump. This
allows the pump to operate as a demand pump and turn on only when
spraying.
Fluid bypass
Pressure
regulator knob
Retaining
nut
Spray Nozzle
Pressure Gauge