Product Manual

Operation (cont’d)

4. Connecting Loads

You will want to be careful when connecting loads so as not to overload the generator, especially if

you are powering devices with motors that require a higher starting power load.

Instructions are provided below for connecting loads when you are using the generator:

o As a portable power source

o Connected to a building as a back-up power source

WARNING:

Do not overload generator. Make sure that combined starting and running loads do

not exceed rated capacity of generator. Overloading the generator can cause damage

to the generator and attached electrical devices, and may result in fire.

Using as a

Portable Power

Source

Connect electrical loads one at a time according to the following

instructions:

1. Allow engine to reach operating speed by allowing it to warm up for

approximately 5 minutes before connecting electrical devices.

2. After engine is warmed up, begin connecting the loads one at a time.

Start with those that require the highest wattage first. The

recommended sequence is as follows:

a. Connect items with motors such as refrigerators, freezers, air

conditioners, or small hand tools, one at a time. Let each motor

stabilize before connecting the next device.

b. Connect any lights you are planning on powering.

c. Connect voltage sensitive equipment such as electronics via surge

protectors. Plug devices such as TV’s, computers, and microwaves

into a UL listed voltage surge protector, then plug the surge protector

into the generator.

3. After connecting all loads, check output voltage again (for generator’s

first use, and periodically after that). Output voltage should remain

within the following ranges:

a. 108-132 volts at 120V receptacle(s).

b. 216-264 volts at 240V receptacle(s).

If output voltage is not within the acceptable range, adjust the engine

speed (if possible). If acceptable output voltage cannot be achieved no

matter what the engine speed, the generator is either overloaded or there is

a problem with either the engine or the generator. Shut off the engine and

refer to the Troubleshooting guide at the end of this manual for assistance

with possible problems.

WARNING:

The generator must be run at the correct speed in order to produce the

proper electrical voltage and frequency. Failure to do so could result in

damage to equipment powered by the generator and possible injury to the

individual.