Product Manual

Component Identification

1. Exhaust Vent: Provides an exit for burner exhaust

gases.

2. High Pressure Water Outlet: A passage for water

to exit pump and enter the hose.

3. Motor: Electric motor powers the pump.

4. Burner: The oil burner is preset and performance

tested at the factory. The Burner may need initial

adjustment for peak performance. See “Oil Burner

Adjustment” section for instructions on initial

adjustment of the oil burner. You will need to use

the handle to tip the pressure washer up in order to

access the Burner from underneath.

5. Fuel Fill Cap: Vented cover for fuel tank.

6. Fuel Tank: The Burner has an 8.25 gal. fuel tank-

kerosene, #1 or #2 diesel, or fuel oil may be used.

Do not mix fuel types.

7. Control Box: Flat surface for mounting switches.

8. Flow Switch: Water activated switch to control on

and off of burner.

9. Pump: A mechanical device that moves and

pressurizes fluid. [Pump oil must be changed after

first 40 hours of use, and then changed every three

months or 500 hours of use. See “Maintenance and

Repair” section for pump oil change instructions

and recommendations.]

10. Gun Hooks: Spray gun storage location.