Owner's Manual

30
numbers.
● Input letters
Example 1: Entering to the interface of selecting file in the
surveying, which needs to input ―SUN1A‖ in the edit box
1) Press [Num.] to switch to the mode of inputting letters.
Select file(.MEA&.COO)
File：
Select file(.MEA&.COO)
File：
[F3]
2) Press [7], then, ―S‖ displays in the edit box;
Select file(.MEA&.COO)
Alph.List
B.S
Enter
File： S
3) Wait 0.4 seconds,
4) then press [7] again, ―SS‖displays in the edit box;
5) Press [7] again, ―ST‖displays in the edit box;
6) The interval of pressing the key [7] twice is not over 0.4
seconds .If over, you can press [▲] or [▼] to correct it;
Select file(.MEA&.COO)
Alph.List
B.S
Enter
File：
ST
Select file(.MEA&.COO)
Alph.List
B.S
Enter
File：
SU
Select file(.MEA&.COO)
Alph.List
B.S
Enter
File：
SS
[7]
[7]
7) Press [5] , ―SUN‖ displays in the edit box;
Select file(.MEA&.COO)
Alph.List
B.S
Enter
File：
SUN
8) Pressing [F3] change [Alph.] to switch to [Num.];
9) Press [1];
10) Pressing [F3] change [Num.] to switch to [Alph.];
11) press [1],as shown below: