Owner's Manual

5.2 0set

Function: set the horizontal angle as 0 °00′00″.

● Press [F2](0set);

● Asking ―Set 0?‖, press [ENT] to set 0 or [ESC] to exit this

operation. In order to make sure the accuracy, you may press

[ENT] lightly.

5.3 Hset

Function: Set the horizontal angle as wanted angle.

● Press [F3] to enter the interface of ―Set HA‖ to set

horizontal angle ;

● In the ―DMS‖ of angle unit mode, if you want to input

―123°45′56″‖，just input ―123.4556‖ in the input box. In the

other angle unit mode , input normally, as shown in picture

below:

Set HA

Exit

Clear

B.S

Enter

HR:

123.4556

● Press [ENT] to confirm the input, or [ESC] TO to cancel.

When over 360°, it will tip ―Overtop!‖

5.4 Hold

Function: Another method to set horizontal angle.

● Turn around the alidade to the wanted horizontal angle and

press soft key [Hold], the turn around the alidade a and the

readout of horizontal angle is ‗hold‘ and not changing with

turning the alidade again, the horizontal angle remain the

same.

● After turning the alidade to aim at the target, press the key

[F1] to set horizontal angle at a new position.

Hold

No Yes

HR：

156°38′54″

> Set?