Owner's Manual

38
6. Distance mode
Press [DIST] to enter the distance measurement mode, which
has two interfaces . The functions of first interface are ―Save‖,
―Meas.‖ and ―Mode‖; The functions of the second interface are
―Offset‖, ―S.O‖ and ―m/f/i‖. The two interfaces shown as below:
Vz:
HR:
278°1223
159°5405
F1
3
F4F2 F3
SD: m
HD: m
mVD:
Vz:
HR:
278°1223
159°5405
F1 3
F4F2 F3
SD: m
HD:
m
mVD:
[F4]
[F4]
6.1 Save
● After pressing [F1], whether recorsing after the completion
of measuring point ,the interface of ―Information‖ appears
after pressing [Yes] (if you haven‘t select measured file,
there will be a interface of ―Select file (.MEA)‖ to let you
select file.), which needs you the point name (Pt.N) ,Code
and target height (T.H). The number of ―Pt.N‖ defaults to
added 1. The code is input according to your need, but the
target height according to actual situation. You can press
[ENT] to save data to measured file.
● When the compensation value is over, the instrument tips
―Over!‖, and the angle data can‘t be saved.
6.2 Meas.
Measure distance and display slop distance, horizontal distance,
and elevation difference. Under the ―cont‖ and ― track‖, you can press
[ESC] to stop measuring.
6.3 Mode
This function is used for the work mode of EDM. These modes
are ―Single‖, ―Rept‖, ―Cont‖, ―Track‖.
EDM Mode
[ 1. Single ]
2. Rept.
3. Cont
Enter
Exit
4. Track