Owner's Manual

40
7. Coordinate mode
Press [CORD] to enter the coordinate measurement mode.
According to the diagram below, please set up the coordinates station,
azimuth, target height and instrument height before coordinate
measurement.
Center of lens
HT(target height)
S D
Center of
instrument
Instrument height
Station(NO,BC,ZO)
HD
Z(VD)
Coordinates of
unknown point
(N1,B1,Z1)
Coordinates of the center of
instrument =NC,BC,ZC+
instrument height
There are three interfaces, which can be switched each other by
pressing [F4].The functions of the first interface are ―Save‖, ―Meas‖,
―Mode‖; The functions of the second interface are ―Config‖, ―BSS‖,
―STA‖; The functions of the third interface are ―Offset‖, ―S.O‖,
―Aver.‖. as shown in picture belown
Vz:
HR:
278°1223
159°5405
F1
3
F4F2 F3
N : m
E :
m
mZ :
Vz:
HR:
278°1223
159°5405
F1
3
F4F2 F3
N : m
E : m
mZ :
Vz:
HR:
278°1223
159°5405
F1
3
F4F2 F3
N :
m
E : m
mZ :
[F4]
[F4]
[F4]
● Save: After pressing [F1], whether recorsing after the
completion of measuring point ,the interface of