Owner's Manual

48
‗P1‘ on the cylinder under this mode. Then calculate the horizontal
distance, azimuth angle and coordinate of the cylinder by measuring
the surface points of tangency P2 and P3.
The average value of P2 and P3 is the azimuth angle of the
cylinder.
P2
P0
P3
P1
PO’
In the menu of ―Offset‖, select ―5. Offset (Column)‖ to enter the
interface of ―Offset (Column) –Prism‖:
Offset (Column)-Prism
SD：
HR： 181°14′01″
m
Meas
HD：
Mode
VD：
T.H
After measuring→
Offset (Column)-Prism
SD： 4.570
HR： 181° 14′01″
m
Meas
HD： 4.575
Mode
VD： 1.004
T.H
If you want to point ‗P0‘, please input its height as zero before
measuring it. If you want to measure ―P0‘‖, input the real height
value, then press [Meas] to start measure. After measuring, press
[Enter] to receive the measured data and enter the interface of ―Offset
(Column) –L.edge‖:
Offset (Column)-L.edge
SD： 4.570
HR： 181° 14′01″
m
HD： 4.575
Enter
VD： 1.004