Owner's Manual

97
10.2.2 Setting station and BSS(backsight point)
See reference in setup BSS and setup station
10.2.3 Stake out road
Before staking out Roadway, please first enter the parameters
required for staking out. e.g starting mileage, space between, ―L
dist‖(left distance), ―R dist‖(right distance), ―L dV‖ and ―R dV‖.
Parameter 2/2
L dist：
Clear
B.S
Enter
R dist：
L dv：
R dv：
Parameter 1/2
Clear
B.S
Enter
Start：
Space：
0
20
[F4]
Enter
After inputting, press [ENT] to enter ‗Roadway- Center‘
interface (if all deviations are zero):
Roadway-Center
Mark：
Edit
S.O
offset：
VD：
0.000
0.000
1.700
T.H：
0.000
The soft key functions under this page are as followed:
Key
Explanation
F1
Setup any mileage and target height
F2
No use in this page
F3
calculate the coordinate of the staked out point first
▲
Current mileage minus space to obtain new mileage
▼
Current mileage plus space to obtain new mileage
◄
Switch between ‗Roadway-Right‘ →‘Roadway-Center‘
→‘Roadway-Left‘
►
Switch between ‗Roadway‘-Left‘→ ‗Roadway-Center‘
→‗Roadway-Right‘
This interface displays the mileage of the mark. You can press
[ESC] to exit or Press [S.O] to enter the interface setting put point
information as following: