Owners manual

Step 6: Attach fly
Step 5: Insert closet pole
Step 7: Secure fly pole and fasten the fly
1) Unfold the fly and stretch out all corners.
2) Place the fly over the tent, making certain
the fly awning is over the front door.
3) Attach the fly to the tent by hooking the
plastic s-hooks on the fly corners to the
d-ring at the stake loops.
4) Stake the fly at either side of the door.
5) Wrap the hook and loop fasteners, sewn on
on the underside of the fly, around the
fiberglass tent poles.
1) Insert the fly pole (D) through the sleeve
found at the edge of the fly awning, over
the front door.
2) Flex the pole and insert each end into the
reinforced metal grommets located on each
side of the door in the webbing.
Disassembly
1) To take down the tent, disassemble in
reverse order.
2) Remove and fold fly.
3) Be sure to leave doors and windows
unzipped to avoid zipper damage.
4) Remove stakes with hammers or stake
puller. DO NOT pull on tent.
5) Carefully disengage poles from fasteners.
6) Keep loose poles and stakes in bags
provided.
3) Stake the front of the fly.
Step 4: Raise tent with Easy-Set Loop, attach hooks and stake tent
1) Locate the Easy-Set Loop at the left end of the tent. Pull the loop in a slow and steady manner
to extend the tent floor.
2) Clip the black pole hooks to the tent frame.
3)
Stake the tent by inserting a stake through remaining stake loops, along the tent perimeter.4)
Make certain the tent floor is pulled out evenly and tightly.
5) Hammer the stakes into the ground at a 45° angle using a hammer or mallet.
1) To place the closet pole (C) inside the
closet, carefully form an upside-down“U”
and insert to extend and support the
closet. Insert pole ends into webbed
pockets at the base of the tent.
2) Wrap the hook and loop fastener on the
closet wall around the pole to secure the
poles in place.
3) Stake the outside corners.
Fully assembled tent appears as shown.
Step 8: Secure guy lines
1) Secure tent using all guy lines and stakes.
Tent must be secured for proper function.
2) Optional mud mat can be attached and
staked into place at the front door.
1) Spread tent flat, distribute evenly.
2) Position pre-attached poles parallel to
each other. See example below.
Fold tent into quarters and again in half.
3) Tightly roll tent forcing air through unzip-
ped openings.
4) Secure with ties and place in carry bag with
stakes and accessories.
5) Tent must be clean and dry before storage.
Store off concrete floor.
Packing the tent
Folded tent
(openings unzipped)
KMT161810 11/15