Product Manual

Page 8 of 18
Measure the distance between the ends of the two shafts (dimension “A”, Figure 1). Each half of the
PTO should be equal to dimension “A” minus two (2) inches.
If the driveline must be cut to a shorter length, clamp the driveline in a well-padded vise to prevent
damage to the shield (Figure 3). Cut the plastic shields 1-1/2” shorter than the shafts.
Repeat the procedure to the other driveline half. Remove all the burns and cuttings.
Apply multi-purpose grease to the inside of the outer (female) driveline section. Assemble the
driveline and install on the tractor and the spreader. Pull on each driveline section to be sure the
yokes lock into place. Make certain the driveline shielding is in place and in good condition.
⚠WARNING
Do not operate this equipment without shields properly installed. This is for your protection. The
manufacturer recommends the use of these shields at all times.
⚠WARNING