STANDARD SNOWBLOWER Operators & Parts Manual
SAFETY PRECAUTIONS 1.Be sure all exposed moving parts such as shafts and adapters are properly guarded and that all coupling devices are securely attached before applying power. Do not use unless all shields are in place. 2.Do not wear loose fitting clothing in the vicinity of any moving parts. 3.Do not exceed recommended ground speed, recommended PTO speed, or recommended horsepower for the unit which you are using. 4.Keep all persons, pets, and livestock away from unit when in use. 5.
PRE-SALE SERVICE AND SETUP OF BLOWERS 6.Check oil level in gearbox. 7.Check all bolts for tightness. 8.Check auger drive chain tension and alignment. Adjust if necessary. 9.Grease PTO universal joints, shield retaining collars, and inner tube of PTO. 1.Turn hood to point directly behind blower.(PTO side) 2.Lift hood assembly off and spread a light coat of grease on outside of blower mainframe pipe. 3.Replace hood assembly. 4.Install hood turner as per instructions. 5.
INSTALLATION INSTRUCTIONS FOR SNOWBLOWER-cont’d P.T.O. SHAFT ANGLES Transmission size P.T.O. Shafts are made to transmit power with angles at universal joints. However, these angles should be kept to a minimum. Larger the angle, shorter the life of P.T.O. Take for example a snowblower sold for a tractor capacity of 60-70 H.P., Which would be attached to a 60 H.P. Tractor, operating at maximum capacity (60 H.P. Continuous). H.P. P.T.O. angles 60@540 RPM Using #50 PTO H.P. 540 R.P.M.
If it is impossible to increase the distance between snowblower and tractor, in order to maintain a reasonable angle at P.T.O., It is recommended to use a large size of P.T.O., That is a greater capacity P.T.O. (Please refer to your dealer for more details). For snowblowers of 100 H.P., an additional gearbox is also available that can be mounted on existing snowblower gearbox, which increased the input shaft height, reducing angle at P.T.O. Joints. This gearbox also has an input speed of 1000 R.P.M.
5 15 17 16 8 2 23 7 28 6 5 14 13 24 25 20 19 9 10 11 12 6 21 22 26 27 3 2 30 1 21 2 31 29 4 18 44 45 48 41 6 51 33 32 34 35 34 37 39 40 46 45 42 38 36 49 52 43 36 47 2 54 56 57 55 53 50 SNOWBLOWER DIAGRAM
SNOWBLOWER PARTS LIST Description Part# Description Qty. Part# Qty. 1 30 Lock Nut M6 1 13 31 Hand Crank 1 1 Main Frame 2 Lock Nut M10 3 Bearing SAPF-206-20 c/w flange 1 32 Mounting Plate For Crank Handle 1 4 Nut M6 1 33 Nylon Washer 1 5 Bolt M10x20 3 34 Special Washer Ø12x0.
