Use and Care Manual

ManualsBrandsNorweco ManualsKitchenSingulair Green Chlorination Feed Tube and Cap

BIO-KINETIC

WASTEWATER TREATMENT SYSTEM

CLEANING AND DISASSEMBLY INSTRUCTIONS

FOR THE BIO-KINETIC

SYSTEM

EQUIPMENT REQUIRED FROM THE

BIO-KINETIC SYSTEM TOOL KADDY

 water hose and spray nozzle

 Bio-Kinetic system universal tool

 rubber gloves

 safety face shield or goggles

 ratchet drive and

" socket

A fresh water supply and sewer drain are required for

cleaning the Bio-Kinetic system.

1. Remove the Bio-Kinetic system from the service

container. Rinse the container and lid. Rotate the four

locking lugs to the outboard position on the Bio-Kinetic

system. Remove the gasketed discharge flange

assembly from the flow deck and rinse it with water.

2. Grasp the top flange of the system with one hand

and insert the disassembly tool beneath each of

the strap handles on the flow deck. Pull up on the

disassembly tool to remove the flow deck and internal

system components from the contact chamber and set

aside. Use the water hose and spray nozzle to wash

the inside of the contact chamber.

3. Use the water hose and spray nozzle to wash off the

filter media. Continue spraying until all sludge and

wastewater have been flushed from the media. Invert

the filter assembly and flush accumulated material

from the baffled perimeter settling zone. Inspect the

perimeter settling zone to be certain that it is totally

clean. Check the flow equalization ports to be sure

they are clean and unobstructed.

4. Wash off any debris that has accumulated on the

surface of the flow distribution deck and baffle wall

shroud. Lay the assembly down on its side and

remove the four wing nuts on the bottom. Remove and

wash the bottom deck plate.

CAUTION: Do not break or damage the molded

plastic tabs on the edge of the bottom deck plate.

Do not remove the remaining deck plates at this time.

Stand the assembly upright and lift up on the flow

distribution deck to separate it from the baffle wall

shroud and deck plates. You may find it helpful to hold

the baffle shroud between your feet when lifting up on

the flow deck.

NOTE: The through bolts will be removed from the shroud

and deck plates when the flow deck is lifted off the baffle

CLEAN BAFFLED PERIMETER SETTLING ZONE

LAY ASSEMBLY ON SIDE

Summary of content (2 pages)

PAGE 1
BIO-KINETIC® WASTEWATER TREATMENT SYSTEM CLEANING AND DISASSEMBLY INSTRUCTIONS FOR THE BIO-KINETIC® SYSTEM EQUIPMENT REQUIRED FROM THE BIO-KINETIC SYSTEM TOOL KADDY      water hose and spray nozzle Bio-Kinetic system universal tool rubber gloves safety face shield or goggles ratchet drive and 7/16" socket A fresh water supply and sewer drain are required for cleaning the Bio-Kinetic system. filter media. Continue spraying until all sludge and wastewater have been flushed from the media.
PAGE 2
BIO-KINETIC® SYSTEM CLEANING AND DISASSEMBLY INSTRUCTIONS (Cont.) wall shroud. Do not remove the through bolts from the flow distribution deck. Rinse the flow distribution deck thoroughly inside and out. Inspect the weir and final discharge zone to be sure they are completely clean. 5. Lift up the baffle wall shroud to remove it from the deck plates. Rinse the inside and outside of the shroud and set it aside.